[medic911]

Ken911. Yeah, I had the spring off and both the engine and tranny on the floor. Could see the mating of the fork on the bearing fingers. Was really surprised to see it become disengaged during install. Because I hot glued the bearing in place, it is less likely that I engaged only the top finger and not the bottom but I suppose it's possible even though I think if I did that, the nearing would swing out on the top as the bottom of the fork pushed in the bottom finger of the bearing

The definition of insanity is doing the same thing over again and expecting a different result so not sure how to make sure it's rock solid this, the third, time.