Hi All,
Ok this pause at the top of the pedal travel is not at the pedal end as the pedal turns freely on the shaft with the cable disconnected at the clutch arm end. Also the spring at the pedal is strong as the pedal flys to the floor once it is tipped in that direction.
So I am now assuming I have an adjustment problem at the clutch arm end which looks like this before I disconnected it.
And looks like this once disconnected.
Then I adjust the bolt in the small arm to 1.2 mm, attach the cable by getting enough play by prying the long arm forward and tighten the bowden adjuster till I have 1mm gap on the small arm bolt.
Now it looks like this
I notice that the adjustment is different now at the small arm bolt and at the bowden adjuster than before. I am unsure what I did differently this time.
The clutch pedal now seems to go right to the top as it should.
I cannot check if I have the required 25mm travel in the cable as I am here alone but will take her around the block to see how it is.
Cheers
Bill