Quote:
Originally Posted by mhariush
I got a check engine light yesterday and as it turns out, my durametric (clone) cable just gives me a red light so I can't connect it. But I picked up a code reader from Harbor Freight today.
I get the following codes:
P0102
P0446
Any idea on where to start? Anyone experienced these? The car starts and runs like it always did
leave car or drive car while figuring this out? |
First of all, when asking this type of question, always include the year and model of the car as it can make a difference in which is the correct answer.
Assuming it is a 1999 car:
P0102 - Mass airflow sensor below lower limit; likely faults: break in the wiring, short to ground.
P0446 - EVAP canister shut off valve below limit; likely faults: purge air line blocked, flow blockage in the EVAP canister