Quote:
Originally Posted by timmy2
Remove the 14 pin connector on the back of the fuse panel and check pins 5&6 on the female side of the connector for continuity to the wires going into the switch.
To test the reverse lamps put a jumper across the male pins 5&6 on the fuse panel side of the 14 pin connector and turn the ignition to run, the reverse lamps should be on.
If the second test doesn't work check fuse #6 in the trunk (should have green/yellow wire to it)
If you have continuity in the engine harness wires and the above test works, then the reverse lights should work.
(Plug a nice clean 14 pin connector back in first)
Good luck, and report back.
Did you change the switch or pin?
Sent from my iPhone using Tapatalk
|
I changed the pin for the reverse switch. I will try the test procedure you outlined if it doesn't work I think I'll be ordering a new switch soon.