|
Minimally, the arms (4-5) must be substantial with good weld attachments. Some yokes, once installed, might prevent flywheel R&R; some yokes might prevent rear sheet metal installation (both can be performed off the stand); some yokes may not fit well against the stepped surface in the case.
After choosing, you will most likely have to fabricate some long spacers to span the case studs with installation nuts, and you may want to drill the blank yoke for stop pin holes (in case you want to rotate and hold engine at various positions).
Purchasing a combination yoke and bench/engine stand mount will avoid most of the above, but at a not insignificant cost difference.
Sherwood
|