[flipper35]

Richard, sorry about Camber. It is tough to find a good dog like that.

Also, ouch on that Exchange move. Would be quicker to load it up on a drive and ship it.

Rick, on that small block Mopar, check out Racer Brown or Hughes for camshafts. Made specifically for the larger tappet bore on those blocks.

I would have invited all of you over for the not watching super bowl party, but the road wasn't fit for anything less than a Unimog (told my boss they should buy me one for a company car). Had to wait for the V plow this morning to get down the road. Our car didn't make it 100' before I had to pull it back with the truck. Sat and waited for the plow to come by then. Finally went by a little after 9:00. Sunny and 4* today with no wind. Last night clearing the drive there were times it was hard to see the front of the snow thrower I was attached to. I hate wind. Get to clear some of what drifted back in tonight.

Anyone know what to treat the bottom of a snowboard with? Emily's is pretty beat up on the bottom and isn't as slick as it what I thought it should be. Her old one goes much better.