[daepp]

We use a table saw at work to "re-point" wooden stakes. We buy the new, 1x2x36" stakes and then reuse them several times as they are expensive.

We have always used Craftsman 10" table saws to do the repointing. They only last a few years, and 10" blades are expensive.

I am looking for suggestions from those more knowledgeable than I about "commercial grade" table saws. We have access to 220, but have always purchased 110. And as we are only cutting 1 by, can I put a smaller blade on it? Will it spin too fast? I have not found a 7 1/4" table saw - perhaps this is a dumb idea? But I can buy several 7 1/4" blade for the cost of one 10 inch. Any advice would be appreciated. Thank you.