Quote:
Originally Posted by mytrplseven
Is it bolted on? How thick is it? If it's just slid over the studs for the wheel, Use a propane torch to heat it overall and then use a soft mallet to hit it all around to loosen it from its surface of the hub. I've had success with putty knives hammered into the junction between the hub and the spacer after I heated it. Hopefully no one applied a glue or sealant to it before it was last installed. Also get some Nut Blaster and spray it around the studs before heating it. WD40 isn't effective enough a penetrant.
|
Not bolted - Never been removed. I will use nut blaster.
Thanks!