So I took the morning off and went to a local Porsche event and this happened.
(Sorry for the terrible photo - trying to capture a glass plaque with the iPhone.)
Then back at it; we need to build this car!
Went at the driver's fender to correct the horn grille/turn signal fitment. Started by cutting out the vertical supports as before.
And reminded myself about tools safety; new wire wheels are sharp. :/
Pushed the fender and its flange around for a bit and ended up with this:
I'm not entirely happy with it; so I'm going to revisit it when I'm fresh.
Here's where I'm leaving things for the evening.
https://vimeo.com/128036364
keith.
(sent from my rotary dial phone.)