|
Registered
Join Date: Feb 2001
Location: Buzzards Bay, Ma, USA
Posts: 620
|
I made a cheap oil pressure tester out of stuff I had laying around and a $3.00 oil drain plug that matches the thread of the oil pressure sender (m18-1.5). Drilled out the center of the oil drain plug and tapped to 1/8" pipe thread. Screwed in a 1/8" steel nipple and used high pres fuel line and clamps to connect a 0-100psi pressure gauge.
Removed oil pressure sender, installed this rig and was able to run engine and see oil pressure in psi. (14.5 psi=1 bar)and confirm my sender was good.
This was way cheaper than replacing the sender!!
Good luck,
Jon
__________________
87 924S
82 924-Gone.
80 924 parts car-Gone.
|