[Garo156]

There is a product from SEM that is a pebble texture rocker panel guard. The process I found for to work on my car was to sand the original finish pretty much flat across its texture and then tape off the shot line on the rocker panel between the ground and the door to give you that sharp level look, tape off anything else you don't want over spray on cuz it does have a little over spray. Shoot the product from about 12 to 14 inches away it will leave a texture. let it sit for about 20 minutes then remove the tape by pulling it back over itself at a 45 deg angle while it is still damp to give you that really nice level line and then do not touch the product for at least 3 hours. This material can then be primed and painted the original color of the car or the color that you desire. The product when it comes out of the can is a clear to opaque color. If you have any questions about this process you can PM me and I will go into it further.