[Raulg]

mytrplseven & Molly55: Thank you both for replying.

I will look at the *********** for a diagram. I looked here at PP and all it shows is the impulse sensor. There is no number for the connector. And will reach out to Plyhammers. I will report back on whether the retaining clip can be had separately.

In regards to the speed sensors, I may have "been taken" a bit at $150 each. But the guy would not replace them unless they were Bosch and he claimed he had a small mark-up on them. That is the reason I try to work on the car as much as possible. He aslo had to repair the connector at the harness end where the speed sensors connect. Some wires were brittle and were shorting out. He showed me the tools he uses to take the connectors apart and feed the cables into new ones. I don't even know where to get those tools.

I could use them for my next repair.

I think the shims are in place. The second mechanic is well known in this area for doing good work, yet expensive.
The first mechanic did refuse to touch the car back when I suggested I would get the sensors for him to install. His shop screwed up a few things that I am working to correct now..
Thank you both.
Raulg