Hi Everyone... attempted to do a wheel bearing swap on my 997 today and ran into an issue while attempting to press the new bearing in.
I was using a Press and Pull kit on the car instead of a hydraulic press and for some reason the bearing just would not go in square... I ended up removing it and trying again and then It got a bit worse... Ended up removing everything and at this point will just do it via Hydraulic press.
The wheel carrier was slightly damaged and I'm looking for advise on how to repair this or if need to replace the entire thing.
There is a small ridge on the right side of the carrier , you can clearly feel it. I was thinking I could just use a dremel to debur it.
Advise would be greatly appreciated !
TIA
