[JFP in PA]

A lot of the universal press and pull kits I have seen are a disaster waiting to happen; they make it far too easy to get to exactly where you are, as they make it too easy to cock the bearings in the hub, and nearly impossible to get them in straight.

I would touch up the ridge (slightly) with a carbide burr and then use the hydraulic press to reassemble the hubs.

Memo for future readers: Either spend the money to get the correct Sir B90 wheel bearing tooling, or plan on removing the hubs and taking them to someone with a hydraulic press. Just about everything else is going to take you somewhere you did not plan to go.......