Thanks for the advise!... whats crazy is I was using the SirTool ... I think I used too small of a front plate when doing the press and that caused the bearing to go out of square... The front plate i used was #13 ,,, which seamed to sit nicely and was only slightly smaller then the bearing, but i should of used the large flat plate. At this point I don't think I can get it in there any other way besides using a press... So going to tackle this now and see if the bearing seats nicely.
Quote:
Originally Posted by JFP in PA
A lot of the universal press and pull kits I have seen are a disaster waiting to happen; they make it far too easy to get to exactly where you are, as they make it too easy to cock the bearings in the hub, and nearly impossible to get them in straight.
I would touch up the ridge (slightly) with a carbide burr and then use the hydraulic press to reassemble the hubs.
Memo for future readers: Either spend the money to get the correct Sir B90 wheel bearing tooling, or plan on removing the hubs and taking them to someone with a hydraulic press. Just about everything else is going to take you somewhere you did not plan to go.......
|