[JonT]

Henry's sealant kit has arrived and I'm waiting on some through-bolt washers and perimeter nuts but the case is cleaned up and ready to go. I'm just not sure when I'll have time to get a helping hand and frankly I like doing things myself. Can this be done easily as a newbie? Any tips or suggestions?

I'll be torqueing the through-bolts down without the O-rings at first to buy some time and going back to remove each one at a time to add the O-rings and retorque.

Question about the application of sealers--the p-fixit video shows a thin bead along the case but others have just rolled on a thin layer on the drivers side case (without the studs side). Whats the correct way?

Thanks