All done. Down to 1gm tolerance. 40-45 gm removed. Now at the low end of the lightest weight group.
Wife not home at moment - so a good scrub in hot water and into the oven to dry off.
The 'stock' piston/pin is on the right in 2nd pic. I ended up taking a fraction off that piston too so it was in balance with the rest.
Afterburn - thanks for your patience and advice.
Regards
Alan 
__________________
83 SC, 82 930 (track) - Stock except for RarlyL8 race headers, RarlyL8 Zork, K27-7006, 22/28 T bars, 007 Fuel head, short 3&4 gears, NGK AFR, Greddy EBC (on the slippery slope), Wevo engine mounts, ERP rear camber adjust and mono balls, Tarret front monoball camber adjust, Elgin cams, 38mm ported heads, 964 IC. 380rwhp @ 0.8bar Apart from above, bone stock:-)
|