So, a couple of hours in tonight. Man, these targas will keep you up at night. I was stressing the final vinyl overlay of the boomerangs...and wondering if I could design a simpler inside cover.
Anyway, thanks to stretchy vinyl and a little heat gun action, I had major success. The hardest part (I think) is now done. Not perfect, but done.
Using the same process as the other side, gluing back to front in stages, and using the heat gun in the front corner, it all came together.
I trimmed leaving alot of excess on the back side:
and then got cocky and test fit the new seal that will go in:
I still need to open the hole and install the center guide pin plate. I wonder where that is...