Keeping it rolling, I decided to revinyl the targa bar interior vents. I went to Home Depot and bought some screen material for less than $6. I bought the replacement vinyl already punched and rough cut by Lakewell. I used scissors to trim the screen to size (following the perimeter of the metal support plate). Then I tacked it in place with blue tape once I got everything lined up.
I used contact cement and an inexpensive plastic scraper to glue down the long sides:
Then I trimmed the short side and edges and glued them down.
Here is the front and the back:
With luck I will install them and the targa bar underneath panel tomorrow.