[Antonov]

Bumping this thread back from the dead. I'm in the process of sorting out an oiling solution for a hot 3.6 in a mid year car. I have access to 2x Setrab 50-150-7612 coolers that I plan on mounting in each fender well, they should fit quite nicely.

My question; is it worth plumbing the coolers with -16 fittings given that the coolers themselves run 22mm fittings? My rationale being that you're only as good as your weakest link. Will the larger -16 fitting and lines provide any more flow vs -12 fittings given that the coolers themselves run 22mm fittings which will act as an orifice.

For reference, I plan on using the factory hard lines that run from the back of the car to the front.

Thanks in advance.

-Dino