[Bobboloo]

Dave,

Also wanted to point out that the 2.4T MFI heads being 29mm intake as Tyson pointed out are also 32mm on the exhaust side. Just incase your machinist picked one up and only measured one side.

Blau,

It's to bad your mechanic led you into a race motor for a street car because a stock 2.4E is a great street motor.


Have you considered going with a set of 90mm RS P+C's? Increasing displacement will bring the torque curve down without sacrificing the HP. Better yet get a used set of 90mm cylinders bore them out to 92mm and Nikasil plate them so you could put in a set of JE 9.8:1 pistons. This will give you a 2.8 motor. This should bring back the low end torque and give you even more top end.