this might be a mute point now, however i thought i would post this for anybody in the future
I had a no start issue, it was the crankshaft sensor-indicator. information below taken from another thread, i took mine to the shop , and this was the issue. $ 200 for the part & $100 for the diagnostic.
******************************
I got the OBD2 Reader to work after reading a posting on Renntech. I added the forum below if anyone else had this problem.
Code Reader Equus Innova 3100C - RennTech.org Forums
Now that the code reader is reading it had 0 codes.
We did have a broken wire on the Crankshaft Position Sensor (pinched,,, my fault) that happened when we took the engine out; We soldered the wire. I am replacing that sensor tomorrow morning just in case (at $230!!!!!). I doubt that is it because there's no reason soldering shouldn't have allowed for plenty of signal.
hope this helps a little
