Thanks All of you, it gives me a lot of inspiration to keep at it , re wiring, ive been over and over and in reading your post Jim., ive just remembered i was going to replace the fusepanel as on the back side im sure i found non continuitty of where there should be some, you know those copper bits at the back where they join to the back of the metal fuse holders, well i remember some are loose so i will address that now and make sure current is going all the way through, because to be honest it was working FINE until i took the friggin fusepanel apart to clean all the wiring but silly me after i labelled each wire with a bit of tape i cleaned them with solvent and wouldnt you know lost all the writing lol, should have left it alone.. hindsight is a very good thing with these cars
I did this paint with brush and will sand smooth after i finish wiring and cabling, heater hoses etc
its a pain sometimes to spray everybit all the taping off not to mention the dust that lands all through the garage making everything blue
Thanks again i will repost when i come up for air again
All the Best Robg
