And the LIST!
New parts list:
Main bearings. std./std.
Rod bearings. std.
ARP rod bolts & nuts.
Rod bushings.
Countershaft bearings. std.
Countershaft sprockets.
Timing chains.
Idler sprockets.
Idler shafts.
Cam sprockets.
Chain rails.
Upper and lower end gaskets sets. (Wrightwood Racing)
Steel head studs. (Raceware)
Oil return tubes.
Oil pressure switch. (OEM)
Oil pressure sender. (OEM)
Barrels and pistons. (Mahle Nikasil)
Intake valves.
Exhaust valves.
Valve guides.
Valve stem seals.
Valve springs.
Cylinder head nuts and washers.
Rocker shafts including inner hardware.
Rockers.
Swivel feet and jamb nuts.
Cam tower oil galley plugs.
Cam end cover plates.
Cam feed lines and pipes.
Air cleaner assembly.
Speed and reference mark sensors.
Oxygen sensor.
CO% sample plug.
Breather hoses.
All new engine fuel lines. (OEM)
Fuel pressure regulator.
Fuel pressure dampner.
Engine tin at speed and reference sensor area.
Center intake boot and clamps.
Rubber vacuum elboes and Y's.
Sheet metal combo bolts.
Intake manifold nuts and washers. (OEM)
Intake manifold heat insulator blocks.
Heater blower fan and rubber mounts.
Exhaust studs and nuts.
Injector seal kits.
Alternator ground cable.
Alternator air deflector. (in back of alternator)
Spark plug wire set.
Spark plugs, ditributor cap, & rotor.
Alternator belt.
Main engine oil pipe.
Cushsion clamp and support bracket for pipe.
Crimp clamps for brake booster venturi assembly.
Stainless vacuum venturi pipe. (OEM)$$$
Support bracket for venturi assembly.
Catalytic covertor heat sheild brackets, captive nuts, bolts, & washers.
Muffler straps & bolts. (OEM)
Muffler tip. (OEM)
Heater pipe sleeves and hose clamps.
Flywheel, pressure plate, clutch disc, throw out brg, flywheel, and clutch bolts.
Pilot bearing.
Misc. mounting hardware.
Stickers for oil fill and air conditioning quantities.
Machined or refinished items:
Crankshaft. Magged, Polished, oil galley plugs r&r and cleaned, cross drilled for better oil delivery.(CCR)
Connecting rods. Recondtioned with new rod bushings. (German Precision)
Cylinder heads. Complete valve job. (MTE Inc.)
964 spec Camshafts. (Elgin Cams)
Plating. (Swift Metal Refinishing)
Fan, housing, strap, and pulley hardware. (Mark Motshagen)
Powder coating. (West Coast Powder Coating)
Used parts sourced:
Heater boxes & cross over pipe.
Stainless heater cross over pipe.
Muffler, catalytic converter, cat. conv. heat sheild.
Plastic heater "S" pipe.
Brake booster venturi assembly.
Speed and reference sensor mounting bracket.
I am sure there are a few items that I have forgotten to include.