I have a 73 Volkswagen THING, its a whole lot of fun and I enjoy it often.
Recently I obtained a factory Hard Top which is kinda rare. Its in great shape too.
Here's the deal, my THING has a roll bar with a
peak in the middle bar 30" back from the windshield.
The top will not go over the bar.
I am considering cutting the roll bar. But how far do I want to cut?
a. all the way off to the uprights.
b. leave enough of the cross bar on each side to weld a straight piece onto
c. cut out the peak part and then weld in a straight bar
I can't weld - well I have but have no equipment.
So I can cut the old bar ( recip saw) but will need to hit a shop in warmer weather to get the welding done
Ideas are appreciated
