|
If you have a drill press:
1. Screw/pin the two good holes together.
2. Clamp the pieces together on the other end, nearest to where you're going to drill.
3. Do the clamping in such a way that you can then clamp the pieces to the drill press table.
4. Use the correct size drill in the drill press and use it to align the pieces on the table and clamp so they can't move.
5. Match drill, taking your time and letting the drill do the work, ie don't push too hard, it's going to be an interrupted cut so take small bites, you won't get a continuous chip.
__________________
Scott
'78 SC mit Sportomatic - Sold
|