Hi
Am currently trying to replace a shoyleft rear wheel bearing. And before o go further i need to establish a part in the back of the housing. You can see by oucs ot is a metal ring with a notch in it.
This is the only washer type thing i can find on either side of whats left of the bearing.
Ive removed the guts of it and not 100% on whether i should remove this notched ring or leave it there? And knock out the rest of the bearing using a punch placing it in the gap.
I have a bearing sealer kit that i have modified to pull a bearing but this notched washer would seem to interfere (if thats what it is) with any sleeve i put over iy to exyracy the bearing case..
Any advice appreciated.
I dont have access to a mobile mechanic due to where i am atm. Any advice or ideas on best way to procees will be appreciated.
Cheers Rob.
