I will try to be as thorough as possible, and am more than happy to answer any questions. More pictures can also be provided.
The car is a 2000 911 with ~197k on the clock. Non factory aero kit and complete repaint. It was involved in an accident on track last year. I ran up and over a bit or curbing that was much higher than anticipated at 40 MPH or so. This kicked the rear end of the car up, and upon bottoming out it put a hole in the oil pan and cracked the bottom of the engine block. I believe this also bent the driver side rent strut, and broke the driver side wheel(cheap cast wheels). There was very minimal body damage to the front splitter with a crack on the driver side lip, and the nozzle cover portion of the headlight also went missing. The gap on the hood from the bumper is slightly uneven as well though it was not completely perfect prior to this incident. Slight rub marks over passenger rear wheel arc can be buffed out. I took care of a portion just to make sure and can get this done if anyone is skeptical
I had intended to swap a ls3 into the car, but time for this has dried up so I am looking to pass the project on. I would be willing to sell either with or without the bulk of the track parts. I can remove the seats/harnesses/cage in about 30 minutes and replace with all stock items.
I am asking 10k as is or 8k without the interior track modifications and GT3 front control arms.
Track parts I put on the car:
GT3 front control lower arms
Tarret rear upper control arms
Michelin Pilot Super Sport tires
Pagid track pads
4 point bolt in cage
Recaro fixed back seats
6 point harnesses
-Still have all stock interior pieces. Rear "seats" were taken out to accommodate the bolt in cage. Both front and rear are in good condition with no large rips/tears etc.
Here's a list of what was done shortly before I purchased the car in spring 2016.
Wind shield and seal*
Front wheel bearings*
Front brake pads*
Front A arms*
Front drop links*
Front struts*
Air oil separator*
Rear main seal*
IMS bearing L&N engineering*
Clutch Kit (pressure plate, disc, throug*hout bearing and pilot bearing)
Spark plugs , tubes ,seals, Coils.*
Intake plenum boots front and rear*
Brake fluid*
Coolant*
Cabin filter*
Rear struts*
Motor mounts*
Gear box oil*
Battery*
Alignment*
Fab speed mufflers*
Any other questions ask away. PM on this site works great.
EDIT: Deposit received, looks to be sold. Thanks all