Quote:
Originally Posted by trond
I removed the clip from the tool and compared gap against a new clip. Found that it was deformed permanently and so chose to not use it. Might not be an issue and maybe I made a mistake. I was considering a complaint about the tool to Pelican but a bit late now. Meanwhile I just thought other users should be careful.
Insert spring clip in tool. Remove and compare shape of clip with a new clip. If they are identical then no issue and I was wrong
|
The wrist pin clip/s under go a slight deformation when using this tool. The stress applied to the spring to get through the tool causes this deformation. Measure before and after and you will see the difference in spring dimension (ID). I stopped using it and went back to my old method (locking forcep and socket).
Tony