Quote:
Originally Posted by john walker's workshop
Chances are slim that you will get an accurate cut without hubs to center the rotors. Then there's the federal limit on how far undersize you can go. Cheap enough to just get new ones. Haven't turned a rotor in years.
|
I checked the specs and New according to what I saw is 24MM. My rotors are 23.75 and 23.5. Minimum is 22MM from what I saw. I figured I could go to minimum and for no more than I drive the car and the fact that I don't track it, be fine for several years until I'm ready to replace the pads that are basically new. I can get rotors turned for about $15 to $20 per side. The least expensive rotor I saw was $52 for a Bosch.