Quote:
Originally Posted by tirwin
You posted right before I could make my next post. I had exactly the same problem. I addressed it the first time by placing the ramps a little closer inboard but I didn't like it.
This time I disconnected the two clamps holding the A/C line next to the pinch weld and pulled the line out of the way. I also used a slotted "hockey puck" to sit right on the pinch weld.
Much more stable.
|
I'll probably do just as you and disconnect the AC lines. I bought some slotted rubber pads which were the same height as the smaller rubber blocks that I'm going to try with next time I need to raise her.
I'm still a noob and am learning but do all Gbody cars have jacking pads in the rear by the torson bar? I thought it was only the 87+ with them. If that is the case then I'm assuming I'm jacking from a further rear position then you are?