Quote:
Originally Posted by Tom '74 911
Had some good success removing the 2 squirters I'd drilled and tapped. This time, I tapped all the way through the bottom of the squirters and they both came out w/a few forceful whacks - the 5mm screw didn't just pull right out - phew!
Now on to the next hurdle - the replacement squirters I received from the machine shop are too big to fit in the existing holes w/out drilling them out. I measured them the other day and if I remember correctly, they are around 6.35mm OD. Are these oversized?
I think I could use stock sized ones if they are oversized, as the holes are pretty unmolested.
Thanks,
Tom
|
Stock are 6mm, oversize are 6.6mm