|
Open the door and toss both the wiper arm and the valve stem inside the car. Close the door. That's what the Factory Race Team would have done until they were ready to race it again.
Thin cyanoacrylate is NOT your friend here. Maybe mix up a pea sized two part 5 minute epoxy and use the end of a pin or needle only after you've stirred the epoxy for about 3 minutes. Good Luck!
or...incredibly small black heat shrink tubing. It exists in the R/C section of a hobby shop.
Last edited by SCadaddle; 01-14-2018 at 05:47 PM..
|