Quote:
Originally Posted by proporsche
Tony ..remove the rear first then you might have more room to go back.The back bolts have stops.to prevent you to go too far back.Once you remove them go all the way back and then use a solid steel drill-bit.
Same goes for the rear go all the way front and drill them out.....
Ivan
seat stops
 |
Ivan,
I have to look again closely on the seat rails. The 2 bolts at the rear (shown in my pic) are attached to a thick backing plate. Where are the “stoppers” you posted located? I have a Dremel and a small pneumatic grinder but the locations of the bolts are difficult to access. Hopefully using the right technique and perseverance could over come this problem. Thanks.
Tony