|
Sal-There is ample room in the tunnel. I did this with engine/trans and fuel tank out. You will have to drill the front and rear firewalls to allow the larger end fittings. Buy 4 grommets from Len to fill the oversize holes.
Unbolt the handbrake and shifter so you can get your fingers into the tunnel. I used an old clutch cable for a fishing tool, and guided it with my fingers as I slid it from rear to the front. There are hoops and tabs in the drivers side upper corner space to hold the fuel lines-run the fishing tool through these.
Insert new fuel lines through the front holes and tape to the fishing tool under the dash, after taping the open ends. Pull these through.
Almost done! Proceed to grommet frustrationl! Push the grommets in place. For me-I could not get them into the oversize holes and finally had to grind them down a bit.
Good luck with it!
|