|
Registered
Join Date: Dec 2002
Location: Dahlonega , Georgia
Posts: 15,207
|
This is the install kit I purchased , it states they are wedge bolts . They are 3/4 " diameter so I drill a 3/4 hole correct ? No mention of epoxy but epoxy could be added right ? Or is there no value adding the epoxy ? In regards to the bit wandering I was planning on using the holes in the foot of each post as my drill guide that will work right ?
I figure I will drill the holes , insert shims as needed and install the bolts . If you guys think some epoxy would be good " insurance " then I will do so . I want to do this right the first time 
https://www.carliftparts.com/product/bendpak-lift-installation-install-kit-16-wedge-anchor-bolts-30-pack-shim-kit/
__________________
2002 Boxster S . Arctic silver + black top/int. Jake Raby 3.6 SS engine " the beast ". GT3 front bumper, GT3 side skirts and GT3 TEK rear diffuser. 1999 996 C4 coupe black/grey with FSI 3.8 engine . Rear diffuser , front spoiler lip with ducktail spoiler .
|