First time I've seen side view. Very nice!

997 - A definite improvement. My gripes: needs the intake at the top of the hood and the very rear end -- I don't know how to say this -- should be turned down some. Um... take the rear clip at the body seam just above the taillights and turn it downward, (if it's at 30 degrees above horizontal now, make it like 10 degrees). This would elongate the tail a bit, and effectively reduce the upturned angle of the lower valence. Once that's done, you could slide the signals down further. I obviously don't know the language of car design.

CJ -- where are the air inlets and door mirror again? :D

JP

I'm with OS on this one. The back end just doesn't look right, and I don't know how to fix it, but something just looks ... wrong. IMHO, the trend, the eyeline, the flow of the eye across the back of the car should be horizontal. 10 deg up, as OS suggests, may even be too much -- 10 deg down maybe even better? Don't know, but I'm sure it'll be offered as an aftermarket option sooner or later. :)

Dan

Yeah, but as others mentioned, still not quite right. IMO the nose is too long/pointy. Here's a quick revision I did:

http://forums.pelicanparts.com/uploa...1088104852.jpg

comments?

Eric -- I'm on the fence about the nose; initially I was going to say it looked too pointy, but I guess I thought more was "wrong" with the tail. I like your revision though.
If you're a photoshop guru, can you "fix" the tail so that the same horizontal line along the bottom of the car remains to the tail, and the piece between the seam above the taillight and the lower edge of the rear valence is enlarged?

It really looks like some giant sat on the tail of the car, lifting the nose into the air and bending the rear of it upwards, from the bottom up.

JP

better, now we need some 18" Fuchs and a duck ;)

I like your revision to the nose length. Now, need to roll the body cleanly underneath and get rid of those ugly turned up valence panels. I would like a traditional 911 hood with the air vent and as othes have said, more upright headlights.
Then please, have it delivered to my door with an RSR motor in it!
Thanks,
Troy

OK, here is EVO II:

http://forums.pelicanparts.com/uploa...1088124507.jpg

And the original again for comparison:

http://forums.pelicanparts.com/uploa...1088124534.jpg

Hmmm ... now that I think about it, I prefer the original back end. The modified one looks too ... fat? The skinnier front looks ok, though. Just my two pennies...

Dan

Ok, I started a new 997 photochop thread on the main board.

happy to comply :)

http://forums.pelicanparts.com/uploa...1088135169.jpg

my portrait at about 60ft.

http://forums.pelicanparts.com/uploa...1088143094.jpg

Ron, NICE mask and regulator-clearing demo!

not exactly that kind of demo. I guess you can't see my tongue sticking out. huh ?

If something else was sticking out? The censor would strike! :)

oldies but goodies

http://forums.pelicanparts.com/uploa...1088185318.jpg

http://forums.pelicanparts.com/uploa...1088185398.jpg

Isabo, I don't know where you come up with your pictures, but you always post hilarious stuff! :)

Thanks.
I work for Milu part-time and I usually steal them from his hardisk. Others are sent by my daughter. The three of us have a similar sick and weird sense of humour.

[img]
http://forums.pelicanparts.com/uploads3/rs07861088376106.jpg[/img]