| svandamme |
12-09-2011 12:15 AM |
Quote:
Originally Posted by Porsche-poor
(Post 6419903)
Good call on keeping them sep. It really depends on several factors. How the bullet it crimped if crimped and the pressure built up by the load. Another good thing to do if you can help it is to make sure all the cases are the same manuf. Some surplus brass is really cheap. I had a few .223 cases split at the neck this summer. Makes for a boring round of ar-15 shooting.
|
I only use Fiocchi brass from factory ammo..
.45 is low pressure, relatively..
And i'm loading em even lower because i don't need full power on thin cardboard at 25 meter anyway.
So case stretch should be ok, and the brass will take a bit longer till it goes brittle.
Each time i finish a batch of reloads, i mark em at the headstamp with a Sharpie.
It's also part of my check after loading, i mark em when i check the primers..
When i'm done shooting, i just grab the brass, chuck em in the bag, and home i can sort em again according to times loaded..
|
