Part Out - 83 930 CIS and Intake

Jim2 · Jim2's Garage

The following parts are from a 1983 930. Individual parts prices are shipping included to the lower 48 states or Canada. US bucks. The engine which the CIS parts came from, from last ran in the late 2000s. I can't vouch for condition beyond what's observed.

PM me your email address for added pictures.

Intercooler with mount bracket $450
Black cast iron fuel head/metering box/lines/injectors $1200
Sold WUR $275 Sold
Intake manifold/throttle body/8 long intake studs $500
Bypass assembly $350
Sold S pipe(rough!)/charge pipe/rubber elbow $150 Sold
Phenolic risers $250
Rear fuel pump/accumulator/hoses/bracket $250
Air filter housing $350

The two pipes and elbow are sold

WUR is Sold

Jim2 · Jim2's Garage

Sold

The two pipes and elbow are sold.

For those looking at the charge pipes and asking questions.

The S pipe has been squeezed down even farther from the factory divot to accommodate a long bell housing 930 trans in a SC chassis (interference at drivers side engine mount). It's not pretty and I suppose with a little work and a torch you could restore it, or run as is.

The aluminum pipe from between the turbo and intercooler is dated 1977 (my engine is 83). It has had the turbo end cut off, presumably to work in conjunction with an upgraded K27 turbo. Then the cut off portion was welded back on, I presume so this engine could be returned to stock intercooler. Measured height is 8.5" while sitting on the turbo end. It appeared to fit just fine on the engine.