|
|
|
|
| Author |
|
|
Registered
Join Date: Mar 2000
Location: St. Paul Mn USA
Posts: 23
|
Rear Alignment shims
Does anyone have a printable template of the rear alignment shims? I have access to a machine shop and was going to make a few for myself. I hear they come in 2mm, 3mm, 4mm, sizes, is this correct?
Thanks pete |
||
08-27-2003, 04:04 PM
|
|
|
Registered
Join Date: Aug 2001
Location: San Francisco Ca
Posts: 697
|
You could take one of yours and trace it. I have not seen a template around, but thats not to say it doesn't exist. Mike Ginter talked about doing one a while back, but nothing really came of it. Might be easier to creep aropund a few junk yards....
__________________
1973 914 2.0 PCA Member GGRwww.pelicanparts.com/gallery/chrisreale/ www.914club.com |
||
|
08-27-2003, 04:06 PM
|
|
|
Registered
Join Date: Mar 2000
Location: St. Paul Mn USA
Posts: 23
|
I don't think my car has any shims on it right now and being in minnesota there aren't many 914's left in the boneyards.
pete |
||
|
08-27-2003, 07:46 PM
|
|
|
Registered
Join Date: Oct 1999
Location: San Ramon, CA
Posts: 1,207
|
Somewhere I have a source that makes them up for something like $10 each or so. Does anyone else have that source or do I need to go through my references?
|
||
|
08-27-2003, 08:18 PM
|
|
|
Registered
Join Date: Apr 2002
Location: Massachusetts
Posts: 438
|
I did this a while ago while mine were out.
 Mark S. '70 914-6 |
||
|
08-27-2003, 08:27 PM
|
|
|
Registered
Join Date: Mar 2000
Location: St. Paul Mn USA
Posts: 23
|
Thanks for the info!
pete |
||
|
08-28-2003, 04:06 PM
|
|
|
