|
|
|
|
| Author |
|
|
Registered
Join Date: Oct 2000
Location: Oklahoma
Posts: 175
|
Parting out 72, 73 and 75
Lots of good stuff that is checked and gone over before it is offered to you. If you need anything I likely have it. I ship anywhere and also take PayPal.
Examples: Tan, uncut door panels: $50 each Exterior door handles with a key: $45 Outside mirror: $40 Blower motor (in car): $40 Blower motor (in engine compartment): $40 Early transmission: $150 Rear valance: $75 Trunk lock with key: $40 axle assemblys: $60 each Sending unit for gas tank: $25 Armrests: Price on request And just about anything else you can think of. Feel free to make me an offer on anything you can think of. All prices are plus shipping from Tulsa, OK, and pictures are available on everything. Thanks! Sammy Last edited by sammy; 09-01-2003 at 06:34 PM.. |
||
08-16-2003, 09:30 AM
|
|
|
Registered
Join Date: Jan 2000
Location: Indy
Posts: 145
|
sammy, i'm looking for a complete front swaybar and all hardware.
|
||
|
08-24-2003, 06:31 PM
|
|
|
Registered
Join Date: Feb 2002
Location: Long Beach, CA
Posts: 460
|
Sammy,
Any early 1.7 or 2.0 (dual pipe) heat exchangers, hanger and heat tubes?
__________________
'75 1.8 -->1911 |
||
|
08-26-2003, 07:08 PM
|
|
|
Registered
Join Date: Oct 2000
Location: Oklahoma
Posts: 175
|
Heater parts
I should have all of these. It is pouring down rain today so it might be tomorrow before I will know for sure.
I know I have a good set of steel heat exchangers and J-pipes. Do you need the ducts as well? Please e-mail me at SnS-TERLTON@att.net and I can send you some photos. Thanks! Sammy |
||
|
08-29-2003, 09:03 AM
|
|
|
Registered
|
i need both headlight covers in light ivory; the 2 little covers over the tunnel: 1 is by the drivers feet, the other is by the drivers hip, the clamp for the pedal board and a seat belt screw that goes into the body by the passengers hip.
James.McLeod@fcps.edu thanks
__________________
73 914 restoration project 73 914 2.0 CIS #80 74 914 1.8L L-jet 83 911SC |
||
|
08-29-2003, 07:25 PM
|
|
|
Registered
Join Date: Dec 2001
Location: Georgetown, MA
Posts: 137
|
I'm looking for a shift rod (hockey stick) for my '70 tail shifter in good to excellent condition. This is the rod that runs from the firewall to the back of the tranny. Also, is the rear valence the early type with the hole?
Thanks Ed
__________________
'74 914 V8 '70 914 |
||
|
08-31-2003, 07:06 AM
|
|
|
|
Registered
Join Date: Sep 2001
Location: Foothills, Ca
Posts: 699
|
Sammy,
Can you send me pictures of the tan door panels?? Thanks
__________________
1973 green 1.7 1973 Orange 2.0 1989 Ford F-150 |
||
|
08-31-2003, 08:19 AM
|
|
|
Not right in the head
Join Date: Aug 2001
Location: Pickerington, Ohio, US
Posts: 402
|
Sammy,
Do you have any 2.0 Fuel injectors and a decent roll bar pad? Thanks! |
||
|
09-11-2003, 06:34 PM
|
|
|
Registered
Join Date: Oct 2000
Location: Oklahoma
Posts: 175
|
fuel injectors
No 2.0 injectors, but I might have a good roll bar pad. I will not know until Tuesday, though, as I have to go out of town today.
I will get back with you then. Thanks! Sammy |
||
|
09-12-2003, 05:11 PM
|
|
|
Registered
Join Date: Dec 2001
Location: Dayton, OH
Posts: 342
|
rust free passenger door?
|
||
|
09-16-2003, 08:15 AM
|
|
orange
