Weltmeister sway bars F+R for early/steel arms

[Sam Grant]

$425 + shipping

95% complete and went on my car complete but when they took it off they seem to have misplaced a few "rod end liners" - they slip fit into the bearing/tie rod end. You can order spare parts from Paragon Products.

Front: I believe the droplinks on the front bar were originally for a late car as they were too short, I extended them so if you wanted originality you will have to contact Paragon - works fine as is and is still adjustable. Many of the parts are new. Missing 3 of the 4 liner things...found one hope to find the others but sold as-is.

Rear: Missing 2 of the 4 rod end liners for the bearing/droplinks where they bolt to the car but everything else is there.

Pic:

Let me know if you have questions, thanks.

Sam

I have the instructions in pdf form saved I can email.

[Sam Grant]

OBO within reason

[banana944]

Do you need to run the liners to bolt them in?

[Sam Grant]

The rears would be OK as-is as (just put one on each side and a washer/nut tightens it down - it wont move.

The fronts I would definitely want to replace the liners....or you might be able to do the same thing by using a larger bolt that would fit tight against the bearing and just add a washer on either side to get the right fit into the droplink bracket...wont be hard to figure out, just being honest with what is included.

Again Paragon or Tweeks? can get the parts, I ordered tons of little bits (all the a-arm mounting hardware is new) as it was all missing when I bought the bar.