Pelican Parts
Parts Catalog Accessories Catalog How To Articles Tech Forums
Call Pelican Parts at 888-280-7799
Shopping Cart Cart | Project List | Order Status | Help



Go Back   Pelican Parts Forums > Search Forums
Reload this Page Search Results
Register Garage FAQ Community Calendar Today's Posts Search


Page 1 of 6 1 2 3 Next » Last »
Showing results 1 to 25 of 132
Search took 0.03 seconds. Search: Posts Made By: ekessel
Forum: Porsche 964 & 993 Technical Forum 10-03-2009, 12:18 PM
Replies: 5
Views: 1,997
Posted By ekessel
I've had good luck supporting the outer edge of...

I've had good luck supporting the outer edge of the squirrel cage on three paint cans, with the motor hanging down in the middle, tap on the motor axle with a hammer and punch until the motor drops...
Forum: Porsche 964 & 993 Technical Forum 09-15-2009, 01:18 PM
Replies: 6
Views: 1,705
Posted By ekessel
I had the same shaky braking feeling and it was...

I had the same shaky braking feeling and it was the front A-Arm bushings. They are available aftermarket and it's not too bad to replace them. I bought the car with 80k on it, after replacing...
Forum: Porsche 964 & 993 Technical Forum 05-09-2009, 10:04 PM
Replies: 1
Views: 717
Posted By ekessel
I recently had to replace the window motor after...

I recently had to replace the window motor after the switch was stuck in the up position for a few days. I bought the replacement motor that came with the "gearbox" attached, but only swapped the...
Forum: Porsche 964 & 993 Technical Forum 05-07-2009, 08:28 PM
Replies: 52
Views: 8,825
Posted By ekessel
Just a warning that these wires may not work out...

Just a warning that these wires may not work out as well as new ones........ been there done that, and wouldn't recommend this.......

-Eric
90 C2
NER PCA
Forum: Porsche 964 & 993 Technical Forum 04-21-2009, 07:58 AM
Replies: 2
Views: 690
Posted By ekessel
Back in 2005 I bought a set of the "wires only"...

Back in 2005 I bought a set of the "wires only" ignition wires from a guy off of rennlist. I had terrible luck with them. The wires were not terminated well, and I ended up unable to use a number...
Forum: Porsche 911 Used Parts For Sale & Wanted 04-19-2009, 08:02 PM
Replies: 7
Views: 524
Posted By ekessel
Are you sure that is for the right side?

Are you sure that is for the right side?
Forum: Porsche 911 Used Parts For Sale & Wanted 04-19-2009, 04:11 PM
Replies: 7
Views: 524
Posted By ekessel
Pictures? -Eric 90C2

Pictures?

-Eric
90C2
Forum: Porsche 911 Used Parts For Sale & Wanted 03-06-2009, 02:16 PM
Replies: 10
Views: 571
Posted By ekessel
Can you post a picture of the back (wondering if...

Can you post a picture of the back (wondering if it fits 964's).

Thanks,
-Eric
Forum: Porsche 911 Used Parts For Sale & Wanted 10-16-2008, 10:15 AM
Replies: 27
Views: 1,885
Posted By ekessel
Where are you located, and what are you putting...

Where are you located, and what are you putting them on? I've got a set of FM10's for a narrow 964 located near Boston that I'd like to get rid of (and not have to ship).

-Eric
90 C2
Forum: Porsche 911 Used Parts For Sale & Wanted 10-08-2007, 05:43 PM
Replies: 8
Views: 594
Posted By ekessel
Still available? -Eric

Still available?
-Eric
Forum: Porsche 964 & 993 Technical Forum 06-29-2007, 06:42 PM
Replies: 16
Views: 34,903
Posted By ekessel
Where can you hook a mechanical gauge up on the...

Where can you hook a mechanical gauge up on the 964?

Thanks,
-Eric
90 C2
Forum: Porsche 964 & 993 Technical Forum 06-20-2007, 07:21 AM
Replies: 91
Views: 7,936
Posted By ekessel
If you've got access to a hammer, or the scantool...

If you've got access to a hammer, or the scantool software, you can read the head temperature sensor in real time...... just a thought.....

-Eric
90 C2
Forum: Porsche 964 & 993 Technical Forum 06-08-2007, 11:43 AM
Replies: 91
Views: 7,936
Posted By ekessel
Yes, you remove the blower fan, and reach into...

Yes, you remove the blower fan, and reach into the back to disconnect the O2 connector. You don't have to remove the wheel.

-Eric
90 C2
Forum: Porsche 964 & 993 Technical Forum 06-07-2007, 10:36 AM
Replies: 91
Views: 7,936
Posted By ekessel
Can you hear the fuel pump? Is it getting loud? ...

Can you hear the fuel pump? Is it getting loud?
-Eric
90 C2
Forum: Porsche 964 & 993 Technical Forum 05-28-2007, 07:51 PM
Replies: 13
Views: 1,070
Posted By ekessel
Replace the DME relay. It goes bad, and you lose...

Replace the DME relay. It goes bad, and you lose the fuel pump randomly........
Forum: 911 Engine Rebuilding Forum 05-14-2007, 10:14 AM
Replies: 35
Views: 7,882
Posted By ekessel
It could have fallen into the tank............. ...

It could have fallen into the tank.............

-Eric
90 C2
Forum: 911 Engine Rebuilding Forum 05-13-2007, 09:13 PM
Replies: 35
Views: 7,882
Posted By ekessel
Is there any update on this engine problem? ...

Is there any update on this engine problem?

-Eric
90 C2
Forum: Porsche 911 Used Parts For Sale & Wanted 05-08-2007, 07:44 PM
Replies: 15
Views: 1,159
Posted By ekessel
Did you find one yet? If not, I've got one off a...

Did you find one yet? If not, I've got one off a used 993 climate controller I scavenged for buttons...... yours for shipping if you want......

-Eric
90 C2
Forum: Porsche 911 Technical Forum 05-08-2007, 07:38 PM
Replies: 15
Views: 893
Posted By ekessel
Janus, Sounds like a good plan to...

Janus,
Sounds like a good plan to me.........

-Eric
90 C2
NER/PCA
Forum: Porsche 911 Technical Forum 05-08-2007, 07:34 PM
Replies: 5
Views: 1,892
Posted By ekessel
They are located on either side of the gas tank. ...

They are located on either side of the gas tank. You need a fancy tool to remove them though........ Check the connector though......

-Eric
90 C2
NER/PCA
Forum: Porsche 964 & 993 Technical Forum 04-17-2007, 07:22 PM
Replies: 7
Views: 1,317
Posted By ekessel
Did you try turning the steering wheel? I found...

Did you try turning the steering wheel? I found it easier with the steering wheel in one specific "rotation"........ (if you've got the airbag steering wheel, the "hub" isn't round.....)

-Eric...
Forum: Porsche 911 Technical Forum 01-03-2007, 07:48 AM
Replies: 15
Views: 811
Posted By ekessel
For more info: ...

For more info:

http://forums.pelicanparts.com/showthread.php?s=&threadid=268570&highlight=billerica
Forum: Porsche 911 Technical Forum 01-02-2007, 11:11 AM
Replies: 15
Views: 811
Posted By ekessel
Good luck! -Eric 90 C2 NER/PCA

Good luck!
-Eric
90 C2
NER/PCA
Forum: Porsche 911 Technical Forum 01-02-2007, 11:07 AM
Replies: 15
Views: 811
Posted By ekessel
I work in Billerica. Let me know if you need...

I work in Billerica. Let me know if you need help.
-Eric
90 C2
NER/PCA
Forum: Porsche 964 & 993 Technical Forum 01-01-2007, 07:26 PM
Replies: 2
Views: 678
Posted By ekessel
Wasn't the throttle position sensor integrated...

Wasn't the throttle position sensor integrated into the tiptronic controller? Not used for 5-speeds....... I think........
-Eric
90 C2
NER/PCA
Showing results 1 to 25 of 132
Page 1 of 6 1 2 3 Next » Last »

 
Forum Jump

All times are GMT -8. The time now is 04:04 PM.

Contact Us - Pelican Parts Catalog for Porsche, BMW, Mercedes-Benz, MINI and More - Archive - Privacy Statement - Terms of Service - Top

 
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2026, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0
Copyright 2025 Pelican Parts, LLC - Posts may be archived for display on the Pelican Parts Website -    DMCA Registered Agent Contact Page
 

DTO Garage Plus vBulletin Plugins by Drive Thru Online, Inc.