Pelican Parts
Parts Catalog Accessories Catalog How To Articles Tech Forums
Call Pelican Parts at 888-280-7799
Shopping Cart Cart | Project List | Order Status | Help



Go Back   Pelican Parts Forums > Search Forums
Reload this Page Search Results
Register Garage FAQ Community Calendar Today's Posts Search


Page 1 of 3 1 2 3 Next »
Showing results 1 to 25 of 53
Search took 0.02 seconds. Search: Posts Made By: nuts4nine14s
Forum: Porsche 914 & 914-6 Technical Forum 05-23-2004, 10:13 AM
Replies: 6
Views: 793
Posted By nuts4nine14s
More information

Here is more information that I gathered.

When I turnt he key to the ON posistion the pump does not run, nor get any voltage. When I crank the car it sits at 12-13v. After the car starts the...
Forum: Porsche 914 & 914-6 Technical Forum 05-22-2004, 09:15 PM
Replies: 6
Views: 793
Posted By nuts4nine14s
Fuel Pump Voltage Problem

OK, I bought a new fuel pump for my 70, 1.7 with FI. I bolted it in and cranked the car over. Car fired right up and dies after about 10 seconds. Well, I found the problem. I hooked up a Multi Meter...
Forum: Porsche 914 & 914-6 Technical Forum 05-19-2004, 02:42 PM
Replies: 6
Views: 921
Posted By nuts4nine14s
I think i need to be more descriptive. I...

I think i need to be more descriptive.

I crank it over and she fires instantly. She idles for about 10 seconds and dies. If i tap the gas pedal it bogs down but starts idling again without dieing....
Forum: Porsche 914 & 914-6 Technical Forum 05-19-2004, 02:08 PM
Replies: 6
Views: 921
Posted By nuts4nine14s
Can stuck valves cause the same symptoms? Also,...

Can stuck valves cause the same symptoms? Also, how do i check the Fuel pressure regulator?
Forum: Porsche 914 & 914-6 Technical Forum 05-18-2004, 12:51 PM
Replies: 6
Views: 921
Posted By nuts4nine14s
Rough Running / Dies

Hello again all.

After finally getting a working fuel pump I finally heard my car run. It is a 70, 1.7 with FI. I replaced all the fuel hoses, Hot tank the gas tank, sent my harness to bowlsby and...
Forum: Porsche 914 Used Parts For Sale & Wanted 04-26-2004, 05:55 PM
Replies: 3
Views: 498
Posted By nuts4nine14s
You have a PM. Luke

You have a PM.

Luke
Forum: Porsche 914 & 914-6 Technical Forum 04-20-2004, 02:22 PM
Replies: 7
Views: 3,623
Posted By nuts4nine14s
Ok, I got my headlights to pop up but I am not...

Ok, I got my headlights to pop up but I am not getting the lights to come on. I have cleaned all the terminals, checked the fuses, and cleaned up the grounds near the headlight motors. Is it possible...
Forum: Porsche 914 & 914-6 Technical Forum 04-18-2004, 07:27 PM
Replies: 1
Views: 571
Posted By nuts4nine14s
Under Dash Access

I have found a few articles regarding the dash removal. I think I can do it but I am wondering what kind of access I will have once it is out. Will I be able to get to the light, hazard, and cig...
Forum: Porsche 914 & 914-6 Technical Forum 04-18-2004, 05:05 PM
Replies: 7
Views: 3,623
Posted By nuts4nine14s
Fuse Box / Relay / Gauge Questions

I am trying to figure out why my headlights won't popup or light up. I have checked all the fuses in the fuse box. I have come across the below relay that says "Hella" on it. Can anyone identify what...
Forum: Porsche 914 Used Parts For Sale & Wanted 04-14-2004, 09:24 AM
Replies: 15
Views: 859
Posted By nuts4nine14s
Need a good working fuel pump that will work with...

Need a good working fuel pump that will work with my 70'

Luke
Forum: Porsche 914 & 914-6 Technical Forum 04-10-2004, 07:46 PM
Replies: 13
Views: 774
Posted By nuts4nine14s
The heads can be swapped? Does that say anything...

The heads can be swapped? Does that say anything about the engine rebuilder? LOL


Luke
Forum: Porsche 914 & 914-6 Technical Forum 04-10-2004, 07:36 PM
Replies: 3
Views: 648
Posted By nuts4nine14s
Sorry forgot to mention. 1970 with tail shifter.

Sorry forgot to mention. 1970 with tail shifter.
Forum: Porsche 914 & 914-6 Technical Forum 04-10-2004, 07:35 PM
Replies: 3
Views: 648
Posted By nuts4nine14s
Shift Linkage in cabin

I have placed all the shift linkage bushings and ball cup bushing. I also had my clutch cable tube flopping around int he tunnel so I re-positioned it and anchored it down so that it no longer rubbed...
Forum: Porsche 914 & 914-6 Technical Forum 04-10-2004, 07:17 PM
Replies: 4
Views: 603
Posted By nuts4nine14s
WOOOOO HOOOOOOOO! After searching the forums...

WOOOOO HOOOOOOOO!

After searching the forums I found an article that lead me to checking all the connections on the relay board. I pulled the FI harness connector, cleaned it and used some...
Forum: Porsche 914 & 914-6 Technical Forum 04-10-2004, 07:03 PM
Replies: 13
Views: 774
Posted By nuts4nine14s
There is a hole behind one of the intake runners...

There is a hole behind one of the intake runners that is almost in the same spot as the driver side. If it is a CHT sensor then I know where it plugs into the FI harness. Is this a critical...
Forum: Porsche 914 & 914-6 Technical Forum 04-10-2004, 06:37 PM
Replies: 4
Views: 603
Posted By nuts4nine14s
Thank you Jeff. Another question regarding...

Thank you Jeff.

Another question regarding the FI control unit. I hooked up my harness, double checked all connections. I read that with the key to the on position I should be able to open the...
Forum: Porsche 914 & 914-6 Technical Forum 04-10-2004, 06:20 PM
Replies: 4
Views: 603
Posted By nuts4nine14s
Injector Plug and THermotime Switch ??

Question 1: I can't seem to locate my thermotime switch. I have a wire comming out of my harness that is supposed to plug into it but I can't find it. The hayes manual shows it right by the dizzy...
Forum: Porsche 914 & 914-6 Technical Forum 04-08-2004, 05:32 PM
Replies: 2
Views: 507
Posted By nuts4nine14s
Be more specific, I might be able to help you...

Be more specific, I might be able to help you out. I am pretty good with the wiring diagrams. What side of the car?

Year, Engine?
Forum: Porsche 914 & 914-6 Technical Forum 04-06-2004, 10:11 PM
Replies: 14
Views: 774
Posted By nuts4nine14s
What do you mean by dowse? Use water?

What do you mean by dowse? Use water?
Forum: Porsche 914 & 914-6 Technical Forum 04-06-2004, 09:20 PM
Replies: 14
Views: 774
Posted By nuts4nine14s
I gave it one quick shaort burst to put the flame...

I gave it one quick shaort burst to put the flame out because I didn't want to clean up all the dust. After words i used my shop vac and a soft bristle brush end to get 99% of it out. I will go back...
Forum: Porsche 914 & 914-6 Technical Forum 04-06-2004, 09:18 PM
Replies: 5
Views: 571
Posted By nuts4nine14s
I guess what I meant was for testing purposes not...

I guess what I meant was for testing purposes not when i am actually drivign the car. Don't all the vacuum hoses have to be hooked up for the car to run properly?
Forum: Porsche 914 & 914-6 Technical Forum 04-06-2004, 08:44 PM
Replies: 5
Views: 571
Posted By nuts4nine14s
Oil Bath air cleaner

Can i run the car without the air cleaner on? For the life of me I can't figure out how it goes on there. Everything seems to be in the way.

Anyone have an engine pic that shows how it goes on?
...
Forum: Porsche 914 & 914-6 Technical Forum 04-06-2004, 08:42 PM
Replies: 14
Views: 774
Posted By nuts4nine14s
Engine Fire

Ok, after many days of sorting through wires, ordering parts from PP and replacing all the fuel lines I had a very heart pounding experience today.

I am still waiting on my fuel pump so I have...
Forum: Porsche 914 & 914-6 Technical Forum 04-06-2004, 08:30 AM
Replies: 4
Views: 579
Posted By nuts4nine14s
Accoarding to the wiring diagram (which i have...

Accoarding to the wiring diagram (which i have become quite familiar with LOL) If looking at the gauge from the back there are 2 leads side by side on the top 2 leads across the center, one on each...
Forum: Porsche 914 & 914-6 Technical Forum 04-04-2004, 04:19 PM
Replies: 5
Views: 1,162
Posted By nuts4nine14s
Found what I needed hope this applies to the 1.7 ...

Found what I needed hope this applies to the 1.7

http://www.pelicanparts.com/914/technical_specs/914_20FI_diag.htm
Showing results 1 to 25 of 53
Page 1 of 3 1 2 3 Next »

 
Forum Jump

All times are GMT -8. The time now is 11:10 AM.

Contact Us - Pelican Parts Catalog for Porsche, BMW, Mercedes-Benz, MINI and More - Archive - Privacy Statement - Terms of Service - Top

 
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2025, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0
Copyright 2025 Pelican Parts, LLC - Posts may be archived for display on the Pelican Parts Website -    DMCA Registered Agent Contact Page
 

DTO Garage Plus vBulletin Plugins by Drive Thru Online, Inc.