Pelican Parts
Parts Catalog Accessories Catalog How To Articles Tech Forums
Call Pelican Parts at 888-280-7799
Shopping Cart Cart | Project List | Order Status | Help



Go Back   Pelican Parts Forums > Search Forums
Reload this Page Search Results
Register Garage FAQ Community Calendar Today's Posts Search


Page 1 of 3 1 2 3 Next »
Showing results 1 to 25 of 61
Search took 0.01 seconds. Search: Posts Made By: 83930
Forum: 911 / 930 Turbo & Super Charging Forum 07-16-2018, 11:55 AM
Replies: 1,455
Views: 194,521
Posted By 83930
I am in the same boat it has my unit and my money...

I am in the same boat it has my unit and my money I’m getting ready to contact the attorney general in Arizona to get things resolved
Forum: 911 / 930 Turbo & Super Charging Forum 02-08-2014, 11:37 AM
Replies: 66
Views: 11,636
Posted By 83930
I had the same experience. Sent back for repair...

I had the same experience. Sent back for repair two years ago. No reply and no contact from them. Steve said to send back for repair. Never heard another thing. 700$ down the drain. I'm sure I will...
Forum: 911 / 930 Turbo & Super Charging Forum 02-08-2014, 11:25 AM
Replies: 8
Views: 1,911
Posted By 83930
Yes I installed mine and it worked very...

Yes

I installed mine and it worked very well for a year and a half, but then had a idle problem. Talked to Steve and he said send it back for repair. Have not heard a thing from him for two years...
Forum: 911 / 930 Turbo & Super Charging Forum 05-07-2011, 03:23 PM
Replies: 15
Views: 1,411
Posted By 83930
You can try checking your advance retard plate in...

You can try checking your advance retard plate in the distributor and check the lines for good fit. My plate one time was stiff and was not working properly.it was in the vacuum actuator,I also had a...
Forum: 911 / 930 Turbo & Super Charging Forum 03-01-2008, 09:47 AM
Replies: 23
Views: 1,967
Posted By 83930
Jay I just finished my install of the...

Jay

I just finished my install of the GHL\with heat on my 83 930. I didn't buy the install kit so I had to do some mods to make things fit. I had to move the oil return line to the front of the...
Forum: 911 / 930 Turbo & Super Charging Forum 12-16-2007, 10:46 AM
Replies: 20
Views: 2,703
Posted By 83930
I replaced a section under the door with a piece...

I replaced a section under the door with a piece of hydraulic line (braided steel and rubber) 6 years ago. Two hose clamps on each end. Hasn't leaked a drop since. With the thermstat fan on cooler...
Forum: Porsche 911 Used Parts For Sale & Wanted 02-17-2007, 09:15 PM
Replies: 1
Views: 300
Posted By 83930
found one!

found one!
Forum: Porsche 911 Used Parts For Sale & Wanted 02-17-2007, 08:23 PM
Replies: 1
Views: 300
Posted By 83930
WTB Front rubber chin spoiler

Looking for a new or near new front rubber chin spoiler for my 83 930. Have seen several for sale here and just wondering if there are any more left. Thanks:D
Forum: Porsche 911 Technical Forum 05-20-2006, 10:06 AM
Replies: 240
Views: 14,453
Posted By 83930
54years young. got the bug in 1970,vw beetle was...

54years young. got the bug in 1970,vw beetle was $1800 new,911 was $3600. couldn't afford either one back then.Got my 930 in 2001 and it wont be owned by anyone else until I'm dead and gone
Forum: Porsche 911 Technical Forum 06-26-2005, 07:30 PM
Replies: 15
Views: 942
Posted By 83930
Check the top corner of the windscreen, had the...

Check the top corner of the windscreen, had the same problem when I was in seattle with no garage. A little clear silicone under the lip of the seal took care of my leak. Oh yea I sat in the car and...
Forum: Porsche 911 Used Parts For Sale & Wanted 06-22-2005, 07:19 PM
Replies: 5
Views: 453
Posted By 83930
Thanks for the reply group911@aol. Have sent you...

Thanks for the reply group911@aol. Have sent you an e-mail.
Forum: Porsche 911 Used Parts For Sale & Wanted 06-19-2005, 08:36 PM
Replies: 5
Views: 453
Posted By 83930
wtb front condenser fan

Looking for a front air conditioning condenser fan assembly for a mid 80's 911 or 930. Would like the entire unit, Motor, squirrel cage fan, and plastic housing.Will look at just the motor and fan...
Forum: Porsche 911 Technical Forum 10-12-2003, 02:33 PM
Replies: 6
Views: 901
Posted By 83930
Thanks Brian. I'll give that a try..

Thanks Brian. I'll give that a try..
Forum: Porsche 911 Technical Forum 10-12-2003, 12:12 PM
Replies: 6
Views: 901
Posted By 83930
cis problem

I hope someone can help on this one. I have a huge vacuum on my fuel tank.1983 930 turbo. After driving for a while, my fuel tank collapes and has destroyed my sending unit.The car runs fine, but...
Forum: Porsche 911 Technical Forum 09-08-2002, 11:50 AM
Replies: 2
Views: 824
Posted By 83930
Unhappy Cracked cylinder

I need some info. I have cracked a cylinder for the second time in 16k miles. The engine is a 3.4 with 8.5 comp and 964 cams, running .8 bar boost and a stock intercooler. Will a fuel management...
Forum: Porsche 911 Technical Forum 01-31-2002, 09:23 PM
Replies: 2
Views: 830
Posted By 83930
That looks like it could be the o-ring on the...

That looks like it could be the o-ring on the tensioner,which seals the chain cover and tensioner matting surfaces.If it is just a seep you probably could drive it for a while until you can pull the...
Forum: Porsche 911 Technical Forum 01-27-2002, 11:23 PM
Replies: 5
Views: 842
Posted By 83930
When I bought my 930 the leakdown on 4 of the six...

When I bought my 930 the leakdown on 4 of the six were at 5 to 8 percent two were at 12 percent. I tore the engine down about 10,000 miles later and the two high percentage cylinders had broken top...
Forum: Porsche 911 Technical Forum 01-24-2002, 11:03 PM
Replies: 16
Views: 1,845
Posted By 83930
My 83 930 does that everytime I start it. Seems...

My 83 930 does that everytime I start it. Seems to be a little blacker when the CO is set a little too rich.Mine is just condensation and soot mixed.I did a complete overhaul about 6000 miles ago.I...
Forum: Porsche 911 Technical Forum 01-22-2002, 05:06 PM
Replies: 12
Views: 3,731
Posted By 83930
I've used my motorcycle jack to take my turbo and...

I've used my motorcycle jack to take my turbo and transmission out. Works well. Jack I have lifts to 24 inches is good for 1000 lbs. and has a 5 ft. t-handle bar for guiding the jack around. The...
Forum: Porsche 911 Technical Forum 01-21-2002, 06:29 PM
Replies: 4
Views: 939
Posted By 83930
The Idle adjustment is on the throttle body(left...

The Idle adjustment is on the throttle body(left side)depending on where it is set it may take a few turns to get it to come down.Mine will idle down in 3 to 5 minutes.your aux air valve and your wur...
Forum: Porsche 911 Technical Forum 01-20-2002, 11:57 AM
Replies: 7
Views: 1,015
Posted By 83930
If you are looking for a home for your black...

If you are looking for a home for your black plastic do-hicky, I might be interested..:D Let me know...Neil
Forum: Porsche 911 Technical Forum 01-14-2002, 06:07 PM
Replies: 8
Views: 780
Posted By 83930
Master cylinder Picture

:( Well Marc. I just got your picture of the master cylinder. It doesn't look correct for my type.Mine has to have two inputs for resevoir,two ports for brake lines and two ports for brake...
Forum: Porsche 911 Technical Forum 01-14-2002, 05:32 PM
Replies: 8
Views: 780
Posted By 83930
Sorry about the mixup. Yea I do have two e-mail...

Sorry about the mixup. Yea I do have two e-mail addresses. The house here is ekoop@nwinfo.net And the house on the coast is kf7uw@skat.net I'm at the first address now. I sent you a PM so I hope...
Forum: Porsche 911 Technical Forum 01-13-2002, 11:37 PM
Replies: 8
Views: 780
Posted By 83930
Hey Marc:::: Checked part number for master and...

Hey Marc:::: Checked part number for master and it is 930 355 011 03. That will fit 1978 - 1989,If You have, send me an email with price and address to mail to. Thanks
Forum: Porsche 911 Technical Forum 01-12-2002, 05:42 PM
Replies: 10
Views: 1,159
Posted By 83930
She's almost as good to look at as the Car:D

She's almost as good to look at as the Car:D
Showing results 1 to 25 of 61
Page 1 of 3 1 2 3 Next »

 
Forum Jump

All times are GMT -8. The time now is 01:10 AM.

Contact Us - Pelican Parts Catalog for Porsche, BMW, Mercedes-Benz, MINI and More - Archive - Privacy Statement - Terms of Service - Top

 
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2026, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0
Copyright 2025 Pelican Parts, LLC - Posts may be archived for display on the Pelican Parts Website -    DMCA Registered Agent Contact Page
 

DTO Garage Plus vBulletin Plugins by Drive Thru Online, Inc.