Pelican Parts Forums - Search Results

		Pelican Parts Forums > Search Forums
Search Results

Garage

Page 1 of 3

Showing results 1 to 25 of 56
Search took 0.02 seconds. Search: Posts Made By: rickkellogg

Forum: Porsche 944 Turbo and Turbo S

06-14-2007, 06:45 PM

Replies: 24

I Want That Bov Sound

Views: 4,232

Posted By rickkellogg

what are some good MAF kits?

what are some good MAF kits?

Forum: Porsche 924/944/968 Technical Forum

05-28-2007, 07:53 AM

Replies: 3

'94 968 Silver Ring on Instrument Cluster Fell Off

Views: 441

Posted By rickkellogg

I was able to pry the edge of the clear plastic...

I was able to pry the edge of the clear plastic cover off enough to slip a telescoping magnet into the instrument cluster and retrieve the loose ring. Sadly, the cover appears to have been...

Forum: Porsche 924/944/968 Technical Forum

05-25-2007, 06:36 PM

Replies: 5

need early 1984- 944 oil pump bolt torque specs.

Views: 1,112

Posted By rickkellogg

I have a factory service manual and the Haynes...

I have a factory service manual and the Haynes manual, bth are a little confusing. The factory manual only shows an M6 bolt size. Two different lengths. The Haynes manual lists the two different...

Forum: Porsche 924/944/968 Technical Forum

05-25-2007, 03:42 PM

Replies: 5

need early 1984- 944 oil pump bolt torque specs.

Views: 1,112

Posted By rickkellogg

Check out the oil pump replacement procedure at...

Check out the oil pump replacement procedure at clarks garage. Look under Oil Pump in the "Garage Shop Manual"

http://www.clarks-garage.com/

Forum: Porsche 924/944/968 Technical Forum

05-25-2007, 03:39 PM

Replies: 13

Allignment Issues... What to do?

Views: 691

Posted By rickkellogg

I just had a similar problem with the rear of my...

I just had a similar problem with the rear of my car. The maintenance shop I use specializes in Porsches. When he was unable to get the proper real alignment he found that the right rear control...

Forum: Porsche 924/944/968 Technical Forum

05-25-2007, 01:05 PM

Replies: 3

'94 968 Silver Ring on Instrument Cluster Fell Off

Views: 441

Posted By rickkellogg

'94 968 Silver Ring on Instrument Cluster Fell Off

Inside the instrument cluster there's a decorative silver ring that goes around the speedo, tach and other instruments. It must just be glued in place as the ring around my tach came loose and now...

Forum: Porsche 924/944/968 Technical Forum

04-15-2007, 01:47 PM

Replies: 4

Key Head Replacement

Views: 1,243

Posted By rickkellogg

I'm about a mile off 123. You don't see many...

I'm about a mile off 123. You don't see many 944's around here. I lost my 83 in a fire and have a 968 now - guess I need to update my signature line. I took the cover of the key head where the...

Forum: Porsche 924/944/968 Technical Forum

04-14-2007, 10:38 AM

Replies: 4

Key Head Replacement

Views: 1,243

Posted By rickkellogg

Key Head Replacement

Bought a new lighted key head replacement, but I'm not sure how to remove the key from the old head. I thought it would just pull out. It's seems to be in the old head pretty tight. Is there a...

Forum: Porsche 924/944/968 Technical Forum

03-17-2007, 03:39 PM

Replies: 16

83 944 Fire

Views: 2,338

Posted By rickkellogg

Thanks everyone for all the posts. It took about...

Thanks everyone for all the posts. It took about 15 minutes for the fire department to get there. By that time the car was completely engulfed. I made it from work just after they put the fire out...

Forum: Porsche 924/944/968 Technical Forum

03-14-2007, 06:53 PM

Replies: 16

83 944 Fire

Views: 2,338

Posted By rickkellogg

83 944 Fire

Lost my 83 today while my son was driving it to school. No one was hurt, but not much left. He said engine began to sputter. He did a U-turn stopped and looked under the hood. There was a small...

Forum: Porsche 924/944/968 Technical Forum

03-11-2007, 10:08 AM

Replies: 1

My New Addition

Views: 417

Posted By rickkellogg

My New Addition

After rebuilding an 83 944 I was hooked. Found this 87 944 Turbo on Ebay and it was about 30 miles from my house. Has 69,000 miles and original paint. No mods...yet. Only quirk I've found is the...

Forum: Porsche 924/944/968 Technical Forum

03-03-2007, 05:22 AM

Replies: 18

worth the $$$$

Views: 973

Posted By rickkellogg

I purchased an 83 that sat for nine years. ...

I purchased an 83 that sat for nine years. Wasn't running and biggest problem I found (in the beginning) was that the gas in the tank turned to shellac. I had to pull the tank and have it...

Forum: Porsche 944 Turbo and Turbo S

02-15-2007, 06:49 PM

Replies: 3

value of 1987 951 excellent shape

Views: 497

Posted By rickkellogg

I just paid 12,900 for an 87 Turbo with 68,000....

I just paid 12,900 for an 87 Turbo with 68,000. Guards Red in excellent condition - new water pump, timing belt, & clutch at 60,000

Forum: Porsche 924/944/968 Technical Forum

01-17-2007, 07:38 PM

Replies: 10

how to remove 944 2.5l engine

Views: 3,976

Posted By rickkellogg

I took my engine out the top. I had already...

I took my engine out the top. I had already removed the clutch housing, but it won't slide off the back of the engine until you loosen the motor mounts and raise the engine a bit so it will tilt...

Forum: Porsche 924/944/968 Technical Forum

01-12-2007, 06:21 PM

Replies: 4

Six years in storage - got a question

Views: 565

Posted By rickkellogg

Was the gas tank drained before the car was...

Was the gas tank drained before the car was stored? I bought an 83 944 that sat for 9-yrs and the gas in the tank had turned to shellac. If there is gas, I would drain the tank and put in fresh. I...

Forum: Porsche 924/944/968 Technical Forum

01-11-2007, 05:52 PM

Replies: 5

Looking at 1986 944 Turbo This Weekend

Views: 620

Posted By rickkellogg

I'll plan on getting the PPI done if the car...

I'll plan on getting the PPI done if the car looks promising when I actually get to see it up close. Thanks! Everyone

Forum: Porsche 924/944/968 Technical Forum

01-11-2007, 06:06 AM

Replies: 5

Looking at 1986 944 Turbo This Weekend

Views: 620

Posted By rickkellogg

Looking at 1986 944 Turbo This Weekend

Just finished rebuilding my 83 944 and it's running... so now I'm looking for something else to try my patience. I'm going to look at the 1986 944 Turbo below. Seller asking $7250 - any advice,...

Forum: Porsche 924/944/968 Technical Forum

12-14-2006, 05:32 AM

Replies: 2

Tail Lights Don't Work

Views: 672

Posted By rickkellogg

Tail Lights Don't Work

Finished complete rebuild, after a week of troubleshooting no spark I replaced the computer and started on first crank... Now taillights and instrument lights don't work. Headlights, brake lights...

Forum: Porsche 924/944/968 Technical Forum

12-13-2006, 01:53 AM

Replies: 20

Engine rebuild complete - won't start

Views: 1,939

Posted By rickkellogg

Oil Pressure is at the top of the acale between...

Oil Pressure is at the top of the acale between 4-5. Before I take it for a longer run, I need to bleed the clutch again and top off the radiator. Anything else I should be worried about...

Forum: Porsche 924/944/968 Technical Forum

12-12-2006, 07:10 PM

Replies: 20

Engine rebuild complete - won't start

Views: 1,939

Posted By rickkellogg

John - Thanks the clacking did go away after a...

John - Thanks the clacking did go away after a few minutes - Can't believe it's running!

Forum: Porsche 924/944/968 Technical Forum

12-12-2006, 05:56 PM

Replies: 20

Engine rebuild complete - won't start

Views: 1,939

Posted By rickkellogg

Thanks everyone for the help - I bought a new...

Thanks everyone for the help - I bought a new computer on ebay and put it in and the car starated on the first crank. Oil pressure is good, but the valves are a little noisy. Have to admit, I've...

Forum: Porsche 924/944/968 Technical Forum

11-26-2006, 03:44 PM

Replies: 20

Engine rebuild complete - won't start

Views: 1,939

Posted By rickkellogg

OK... Confirmed coil wiring and picked up a...

OK... Confirmed coil wiring and picked up a multimeter with an RPM setting. Also did something I should have done earlier, check the resistance of the coil primary and secondary. Based on the coil...

Forum: Porsche 924/944/968 Technical Forum

11-25-2006, 08:31 AM

Replies: 20

Engine rebuild complete - won't start

Views: 1,939

Posted By rickkellogg

SoCal - Thanks for the detailed steps, so far no...

SoCal - Thanks for the detailed steps, so far no good news. There is voltage at the coil. The voltage on the injector plug reads identical (battery voltage) on both terminals. I was able to adjust...

Forum: Porsche 924/944/968 Technical Forum

11-24-2006, 04:51 PM

Replies: 20

Engine rebuild complete - won't start

Views: 1,939

Posted By rickkellogg

Thanks - I did try switching the wires. In both...

Thanks - I did try switching the wires. In both cases engine does not fire and tach does not jump. It appears from Clarks garage that the sensors are labeled pretty clearly (BG, DG), but the plugs...

Forum: Porsche 924/944/968 Technical Forum

11-24-2006, 04:03 PM

Replies: 20

Engine rebuild complete - won't start

Views: 1,939

Posted By rickkellogg

I actually pulled and rebuilt the engine myself. ...

I actually pulled and rebuilt the engine myself. I did remove the sensors intact before removing the clutch housing. I also adjusted them to spec (but without gluing a washer) when I reinstalled...

Showing results 1 to 25 of 56

Page 1 of 3

Forum Jump

All times are GMT -8. The time now is 01:22 PM.