Pelican Parts Forums - Search Results

		Pelican Parts Forums > Search Forums
Search Results

Garage

Showing results 1 to 19 of 19
Search took 0.01 seconds. Search: Posts Made By: LPDandrea

Forum: Porsche 964 & 993 Technical Forum

01-26-2007, 09:35 PM

Replies: 17

964 stalls out, relay?

Views: 5,573

Posted By LPDandrea

Probably no one will beleive this, but try...

Probably no one will beleive this, but try cleaning your battery terminals. I have to clean my ground connection about every two months. Guess how I know when to clean it. That's right, when it...

Forum: Porsche 964 & 993 Technical Forum

10-13-2005, 04:06 PM

Replies: 22

Must VENT - cannot get engine oil filter off no matter what I try

Views: 2,496

Posted By LPDandrea

I go with the channel locks or chain wrench...

I go with the channel locks or chain wrench suggestions. It'll come.

Forum: Porsche 964 & 993 Technical Forum

09-14-2004, 11:34 AM

Replies: 12

'89 964/C4 - Intermittent Total Electrical Failure

Views: 1,858

Posted By LPDandrea

I have had very similar symptomes on my '91. Any...

I have had very similar symptomes on my '91. Any time that a large electrical load like the rear heater fan came online it would momentariliy kill the engine. If this happened sitting still idling...

Forum: Porsche 964 & 993 Technical Forum

09-02-2004, 04:30 PM

Replies: 1

Are Flywheel Bolts Reusable?

Views: 973

Posted By LPDandrea

Are Flywheel Bolts Reusable?

I have read speculations from various bulliten boards that the Flywheel Bolts on a 1991 3.6 are not reusable. The torque spec is only 66 ft. lbs. which doesn't seem too high to me for a hardened...

Forum: Porsche 964 & 993 Technical Forum

08-19-2004, 02:33 PM

Replies: 7

High Mileage 964 - Do you have one -

Views: 2,042

Posted By LPDandrea

I have a '91 C4 Targa with 132,000 miles which...

I have a '91 C4 Targa with 132,000 miles which seems low compared to some. But it runs great and I love driving it. I'm putting a clutch in it now and replacing a few seals just for fun. It will...

Forum: Porsche 964 & 993 Technical Forum

07-14-2004, 03:37 PM

Replies: 1

'97 993 C4S - What's it worth?

Views: 721

Posted By LPDandrea

I couldn't put a dollar figure on it for you but...

I couldn't put a dollar figure on it for you but I can offer this:

I own a high mile '91 C4 Targa (admittedly not the most desirable late model) but it is in very good condition - I would drive...

Forum: Porsche 964 & 993 Technical Forum

07-10-2004, 11:25 PM

Replies: 2

Does this look like the LUK update?

Views: 689

Posted By LPDandrea

Does this look like the LUK update?

Can anybody tell if this is the updated flywheel? LUK is stamped in the hub as you can see in the photo but it is dual-mass. I was under the impression (possibly mistaken) that only the Freudenburg...

Forum: Porsche 964 & 993 Technical Forum

07-10-2004, 10:59 PM

Replies: 11

91 C4 how to separate engine from tranny?

Views: 961

Posted By LPDandrea

Thanks to all who've helped me work on my clutch....

Thanks to all who've helped me work on my clutch. Check out the condition of the disc in this Photo...

BTW is the updated LUK flywheel that I've heard so much about also dualmass? Mine appears...

Forum: Porsche 964 & 993 Technical Forum

07-07-2004, 11:50 AM

Replies: 11

91 C4 how to separate engine from tranny?

Views: 961

Posted By LPDandrea

britwrench, Thanks for the help. I am looking...

britwrench,
Thanks for the help. I am looking for a manual...what is Adrian's book that you refered to? I need all of the info I can get. I hate working without manuals!

Forum: Porsche 964 & 993 Technical Forum

07-06-2004, 02:56 PM

Replies: 11

91 C4 how to separate engine from tranny?

Views: 961

Posted By LPDandrea

John, Thanks for the confirmation on disassembly....

John, Thanks for the confirmation on disassembly.

Concerning reassembly, do I need to slide the fork into the t/o bearing as I slide the engine into the gearbox or can I bolt the engine up...

Forum: Porsche 964 & 993 Technical Forum

07-03-2004, 09:52 PM

Replies: 11

91 C4 how to separate engine from tranny?

Views: 961

Posted By LPDandrea

I got them apart by removing the pivot pin for...

I got them apart by removing the pivot pin for the clutch fork. Was this the proper method? It seems like it is going to be difficult to reverse this procedure.

Anybody know?

Forum: Porsche 964 & 993 Technical Forum

07-03-2004, 10:21 AM

Replies: 11

91 C4 how to separate engine from tranny?

Views: 961

Posted By LPDandrea

91 C4 how to separate engine from tranny?

I have the engine lowered and everything unhooked but I haven't yet found the way to slide the engine away from the transaxle. I'm assuming that this has something to do with how the throwout...

Forum: Porsche 964 & 993 Technical Forum

10-14-2003, 12:07 PM

Replies: 17

What do I need to watch out for when buying my first 964?

Views: 2,267

Posted By LPDandrea

I have a '91 C4 Targa 5spd with 132k on it. I've...

I have a '91 C4 Targa 5spd with 132k on it. I've owned it for three years and have had no major problems. I bought it from a friend and know that he and his wife only had to pay for regular...

Forum: Porsche 964 & 993 Technical Forum

04-28-2003, 11:55 PM

Replies: 3

How would one reset an odometer?

Views: 1,174

Posted By LPDandrea

How would one reset an odometer?

I recently purchased a brand new speedometer on ebay for my '91 C4 and was told that the mileage on the odometer would automatically change to what was stored in the on-board computer. This has not...

Forum: Porsche 964 & 993 Technical Forum

02-04-2002, 02:00 PM

Replies: 2

How does the water get into my tail lights?

Views: 1,228

Posted By LPDandrea

How does the water get into my tail lights?

My left rear tail light on my '91 C4 keeps filling with water. I just replaced it with a new factory unit , connected all of the hoses and it still gets water inside. What gives? Anyone else had...

Forum: Porsche 964 & 993 Technical Forum

12-10-2001, 11:07 AM

Replies: 32

'91 C4 pitfalls? Looking to purchase one...

Views: 3,842

Posted By LPDandrea

Paul, I have a '91 C4 Targa with 125,000...

Paul,

I have a '91 C4 Targa with 125,000 miles on it. I drive it every day and autocross it. I have been thinking of trading up to a C4S but I know this car so well now that I hesitate to start...

Forum: Porsche 964 & 993 Technical Forum

12-08-2001, 11:01 PM

Replies: 11

Handling improvements for the 964 C4

Views: 2,461

Posted By LPDandrea

Bill, I have a 91 C4 that I autocrossed this...

Bill,
I have a 91 C4 that I autocrossed this summer (7 events). For six events I struggled to learn to drive this car without massive understeer. Then I found on ebay a set of H&R springs mounted...

Forum: Porsche 964 & 993 Technical Forum

09-06-2001, 05:19 PM

Replies: 0

C2 Turbo Struts on a C2/4?

Views: 790

Posted By LPDandrea

C2 Turbo Struts on a C2/4?

Does anyone know if C2 Turbo Strut/Spring assemblies will fit on a regular C2/C4?

How are they different?

------------------
Louis
'91 C4

Forum: Porsche 911 Used Parts For Sale & Wanted

12-28-2000, 11:27 PM

Replies: 0

C4 Heater Control Panel

Views: 440

Posted By LPDandrea

C4 Heater Control Panel

Looking for a heater control panel for a '91 C4 Targa. I've heard that 944's used the same panel but have not verified this. Anyone?

Showing results 1 to 19 of 19

Forum Jump

All times are GMT -8. The time now is 03:51 AM.