|
Matt: Tech tip...
When you apply your Curil T, use a clean sheet of paper from an 8.5x11" tablet, and lay the paper on a flat, clean surface. Put your gasket for the diff housing to intermediate housing on the paper, diff housing side up. Squeeze out a thin bead of sealant onto the gasket and spread as already discussed. Place the gasket on the diff housing and the Curil will stick it in place. Make sure it's lined up with the stud holes in the lower left corner.
Now apply a thin bead of sealant to the intermediate housing sealing surface, spread it evenly, put the shift rod in the housing, and hold it so you can see that the detent is "down." Slide the housing into position being careful to not tear the gasket where the two studs pass through it into the diff housing.
Repeat procedure for the nose cover.
__________________
Keep the Shiny Side UP!
Pete Z.
|