Quote:
Originally Posted by tomkirkcis
Hi guys
I am confused by the pin out of the later 6 pin Bosch CDI. There is a diagram on the side of the unit. Is that the diagram of the male pins on the unit or is that the diagram of the female connectors in the cable to the u nit.They would not be the same, they would be the inverse of each other. I did a search and found a cllassic post by Warren. Here it is.
]Here is the pinout looking into the connector with the mounting flange sitting on the hand or table ...
. 31/1 ... TD ... 31d
. A . . . . 15 . . . 7
==============
31/1 -- Power ground
31d -- Signal ground [green coax shield] for trigger signal
15 -- +14 Volt power lead
7 -- Trigger signal from distributor magnetic pickup coil
TD -- Tachometer Drive signal
A -- +460 Volt pulse output to coil
__________________
Warren Hall, Jr.
If I am reading this correctly, this is the schematic of the female connector and not the pins on the cdi unit. Can anyone confirn this or post an image of the connector so I can see the wire colors entering the connector.
Thanks
|
Tom,
The connections for 7 and 31/d are interchanged. The green wire should go to terminal #7. Send reply to
atd911@hotmail.com and will forward the coded wire color for the 6-pin Bosch CDI.
Tony