|
Impossible to get the roll pin in the pedal cluster to move....
I am in the process of rebuilding my pedal cluster with bronze bushings. However, I can't get the roll pin that holds the clutch pedal in place out. I have tried drilling, but I have not succeeded in drilling all of it out. I have tried heating it up and then smashing at it with a punch and a big hammer. I have tried the mechanical press I have in my garage, but it is impossible to get the pedal cluster orientated properly for it to work.
So, can I just use a grinder and cut a slot in the pedal, and just weld it back afterwards when I am done? Or will this not work? I am really sick and tired of this now, have spent two days on the damn thing...
|